Extension Cable 2Pin/3Pin/4Pin/5Pin/6Pin/8Pin/9Pin Waterproof Plug Works for Electric Bicycle Light/Throttle/Ebrake/Display Ebike Parts Extend Cable (2pin 80cm)

Very good produeced. worked no problem.

Prefect fit and quality this wire worked great to wire in my new Brake light on the Emoto Dirt Bike.

Transporting my bike on a bus, combined with it falling over from a collapsing kick stand (grrrr!!!!), stripped this cable, which enables you to operate your display/battery assist. Ride1UP doesn't provide replacement cables, incredulously, so you're on your own! Why?To install, I essentially had to do a bypass, because once removed from the tube, it's virtually impossible to needle the cable through the many metal barriers inside the tube, and so I ran it on the outside, then taped it over to protect it from the elements.Now that it's successfully installed, I'd argue it performs even better than the original cable! The performance is exceptional!I'm deeply appreciative this cable is available on Amazon, because e-bike stores and bike shops informed they don't carry this cable. Not even Ride1UP provides it! (What?!?)If I get another e-bike, it's going to be one where I can get the replacement components locally.

Haven't used but looks good

I bought an aftermarket rear rack for my new Evelo e-bike as the manufacturer's was on backorder for months. That covered the existing brake light attached under the seat. So, I extended the cable coming out of the frame with this little red cable to the back of the rack where it would face traffic. Did any drivers or crossing pedestrians look up from their phone to notice? Who knows. But it's better than having the brake light buried!The Evelo rack has now come and has its own brake light. If this company sells a y-cable, I may re-use the other one mounted higher up. See and be seen! BTW this and any other cable will work on any Canbus-based e-bike. You simply match the color and number of pins on the connector.

These cables are well-made extensions for HIGO or Julet ebike cables. I have used probably a dozen of them in a variety of pin versions for a number of different ebike builds. Absolutely zero problems and the cable ends are not brittle nor do they have loose exterior housings like you see on some of the cheaper HIGO clones.

I wanted to have a more relaxed riding position on my e bike. So I feel I was able to find an extension for the wiring harness brake switch. It would have been hard to splice

the connector was slightly bigger then the one on my bike and wouldn't go in