Titanium Exhaust Wrap 1" x 16' Roll for Motorcycle Fiberglass Heat Shield Tape with Stainless Ties

I was upset when I realized this wasn’t the 2” wrap but due to my lack of space to work, I’m glad it was the 1” 😂 made my job easier actually.

My 8+ year old Cub Cadet riding mower tends to run hot (though, I think I've fixed that with new head gaskets) but the worst part is, the exhaust pipe runs RIGHT by the plastic hood bracket. After running for a while it will literally melt the bracket (and ruin the hood, too.) Dumb design for sure, but after carefully wrapping the two pipes (and this kit had plenty of wrap to do a twin-cylinder lawn mower engine) and using the stainless zip ties - I don't have to worry about melting brackets or wiring looms anymore. Definitely lowered the amount of heat they radiated.Note - the stainless zip ties don't work on the same principle that regular plastic ones do; they don't have the little ridges and lock that snaps into place. Instead, there's a tiny ball inside the head of the zip tie that gets forced back into place and locks the zip tie. They can be difficult to work with by hand BUT there is a tool that several sellers here on Amazon sell specifically for stainless zip ties. Considering I have a lot of other uses for stainless zip ties around my property (holding chicken wire to metal fence posts, for example) I spent a few extra bucks to get it. The tool not only gets the zip ties really nice and snug (more so than you can do by hand) but it also snips off the end of the tail flush. To wrap exhaust properly I'd suggest getting the tool, especially if you intend to use a lot of the stainless zip ties. (You'll probably find you have more uses than just exhaust wrap for them!)

As advertised and as expected, however with the material being so long in this case they should include more metal clamps. 3 is not enough for the length of the product.

Not too bad. Used this on my tractor to help with heat but also because it looks cool. Easy to put on. Just make sure it's tight on each turn. Clamps hold well so far. I used a torch to burn off loose ends and frizzies

This should come with better warnings about the application. I would have worn metal gauntlets to put it on. It took almost a week to get the insulation shards out of my hands. But, it insulated the exhaust pipe ok.

Was more than enough for my exaust on my predator 212 looks slick

This tape was misleading I thought there was more coming and it's not wide at all it's only like less than an inch so I didn't really do anything that I needed it to do other than that functionality I guess as far as heat tape goes it was good and it was carbong like I wanted it

It worked